Wi-Fi Temperature Sensor Mini

Installation Manual » Sales Sheet » Submittal »

Product Overview

  • Compatible with ColorTouch (T7850, T7900, T8850, T8900).
  • Compatible with Explorer (T3700, T3800, T3900, T4700, T4800, T4900, T4900SCH).
  • Compatible with Explorer Mini (T2000, T2050).
  • Setup using the Configurator App
Where to Buy

Pair to your Explorer Mini thermostat:

1. After successfully connecting the sensor to the access
point, momentarily press and release the link button of
the Wi-Fi sensor. The LED of the sensor will stay on for
up to 2 seconds, then turn off.

2. Open your desktop app for Skyport (Skyweb). Go to
the thermostat you wish to pair the sensor to.

3. Click on the 3 vertical dots. Select Sensors.

4. Select + Pair a new wireless sensor.

5. Select Pair on the desired sensor listed.


Note: To set the use of the wireless sensor by the Explorer Mini:

1. Open your desktop app for Skyport (Skyweb). Go to
the thermostat you wish to pair the sensor to.

2. Click on the 3 vertical dots. Select Settings.

3. Select Sensor Settings, Choose the Control Source
and the Wireless Sensor to Use.

To Unpair the Wi-Fi Sensor from the Explorer Mini thermostat:

1. Open your desktop app for Skyport (Skyweb). Go to
the thermostat you wish to unpair the sensor from.

2. Click on the 3 vertical dots. Select Sensors.

3. Click on the Trash icon to delete a sensor and confirm.

Pair to your Explorer thermostat:

1. After successfully connecting the sensor to the access point, momentarily press and release the Link button of the Wi-Fi sensor. The LED will stay on for up to 2 seconds, then turn off.

2. Open the ‘small, inside door’ of the Explorer thermostat.

3. Press the Accessory Setup button.

4. Press the Mode button.

5. Upon successful pairing the thermostat display will acknowledge the paired sensor, along with the sensor’s ID.



To Unpair the Wi-Fi sensor from the Explorer thermostat:

1. Open the ‘small, inside door’ of the Explorer thermostat.

2. Press the Accessory Status button.

3. Press the Cooler (down arrow) button.

4. If you have more than 1 sensor press the Mode button until the sensor you wish to unpair is displayed.

5. Simultaneously press the Warmer (up arrow) and Cooler (down arrow) buttons.

6. The thermostat display will acknowledge the sensor unpaired.

Pair to your ColorTouch thermostat:

1. After successfully connecting the sensor to the access point, momentarily press and release the Link button of the Wi-Fi sensor. The LED will stay on for up to 2 seconds, then turn off.

2. Press ‘Menu’ on the bottom right of the ColorTouch display.

3. Select ‘Settings”. (you may need to scroll down to Settings)

4. Select ‘Installation Settings’. (you may need to scroll down to Installation Settings)

5. Select ‘Sensor Settings’.

6. Select ‘Wireless Sensors’.

7. Select ‘Add New Sensor’.